I installed my superwinch 4500 on my 18' ranger 1000 yesterday and decided to add dash mounted switches to give it a clean look. I elected to have 2 switches, 1 for power and one for running the winch so I can turn off the in/out switch if it ever fails. Cut all my pig tails and hooked up loosely and everything worked perfectly. Cut the dash squares out and went to push the 2 switches through and they are SMALLER than the holes by 1/4 inch vertically! All that time installing and never thought to double check the cutouts to the switches... now I have two black rubber shims taped to the bottom of the switch to keep it snug but I am not thrilled with that for the final product. Anyone have any ideas for a better fix or know of switches that fit the stock size cutout in a ranger?