Polaris Ranger Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 9 Results
  1. Polaris Ranger XP1000
    I have a 2019 XP1000 Ranger with about 2,300 miles on it & about 600 hours. I've noticed that when I press the gas to go, it used to engage the clutch at about 1,800 rpm, but now it's like 2,300 rpm. I plan to try to investigate this weekend and also dig into the maintenance manual, but was...
  2. Polaris Ranger XP1000
    I bought the Gilomen Innovations tune and monster clutch kit for my 22 NS Crew Trail Boss. I went with the Low RPM configuration (loading magnets into the clutch weights) and while I have to say I am very pleased with the machine and the performance gain I can't help but think I might like the...
  3. Polaris Ranger XP1000
    Hi, I've been dealing with some clutch issues that appeared randomly a few weeks ago. I did quite a bit of research and wound up changing the belt, the whole primary clutch and the spring and helix on the secondary with a kit from Aftermarket Assassins found here. Unfortunately this didn't fix...
  4. General Discussion
    I never had clutch problems when it comes to Polaris so I may be uneducated about them but at higher speeds I feel like I should be going faster than I actually am due to the engine noise, ex” on the road going 50mph I will start up a hill not even steep I will lose speed the whole East’s down...
  5. Polaris Ranger 570
    Just got back from a 1 1/2 week adventure with our 2015 midsized ranger 570. We had a great time, but had a few hiccups with the primary clutch. One time when I stopped to shift gears, the belt didn't release at all. The engine died and when I tried to re-start, I was driving the vehicle with...
  6. Polaris Ranger 570
    I’m having a problem shifting gears when the Ranger is on. The idle is high 1300-1400 rpm. When the Ranger is off I can shift gears like normal. So I have turn it off to put in gear then turn back on. I’m new at this, don’t know where to proceed, I’ve checked all the easy things like water in...
  7. General Discussion
    I was looking for some advice on a new clutch. 2019 Polaris Ranger 1000XP Crew. I am running 32" motohavoks on 18" rims. I have a gillomen innovations ecu tune and was running their clutch kit and mudder spring. S3 4 inch lift kit. After a weekend of fun, my clutch came apart, busting my...
  8. Polaris Ranger XP1000
    I had a problem with my 2020 Ranger Northstar, with the shifter being hard to move and on occasion it would make a grinding sound and lurch forward. My dealer adjusted the clutch and now when staring from a stop my Ranger has a loud clunking noise. My dealer said that was normal and comes from...
  9. Modified Tech Discussion
    I just put a new primary clutch on this Ranger, and it's slowly spinning the secondary clutch in neutral, making it really hard to get into gear, or out of gear. My question is this, why do some clutches seem to have no "bearing", like this one (the center bushing does not rotate at all), and...
1-9 of 9 Results
Top