Search Results for ‘fuel pump’

My 2020 XP 1000 crew started acting up this weekend. Check engine light came on and went into limp mode. Turn off and back on and made it 30 miles. Now engine light comes on and no power at the pedal, idles like normal until I hit the gas. Checked fuel pressure at the rail and have 60psi. Any...

Need some help, new member and new to Polaris world, recently acquired a gently used 2005 polaris 500 ranger efi 4 x 4. I am no expert or pro mechanic...but it has an issue with the fuel pump and gas tank. Seems both have really bad corrosion I assume is from water in the tank? What is best...

I have a 2017 ranger 1000xp Fuel pump not coming on during start. Jumped pump with 12v and runs fine. Replaced relay, ignition switch, fuses, tmap sensor, and ecu. Still no joy. Can’t see any chewed wires. Any ideas? Looking for wiring diagram to see if ecu is sending signal to relay to engage?

I have a 2017 ranger 1000 xp. The fuel pump is not getting power. I replaced the relays and fuses. I replaced the ignition switch and the tmap sensor. If I jump power to the pump it works and will start. But it isn’t getting power sent for some reason. Does anyone have any other ideas?

The reason I ask is kind of a long story, but in short...I think my dealer screwed me a few years ago when I let him supposedly replace the entire fuel tank to remedy a bad fuel pump. When I picked it up I told him the tank didn't look new...it was dirty and still had the old gas cap. He said...

I have read posts saying that 2012's were known to have problems with fuel pumps being weak. I have also read that dealer will install higher pressure 2013 pump and flash computer and cover this under emissions warranty. Is this true? and if so how long is emissions warranty good for? Mine is...

Hi All, I just bought an 2009 700xp and the fuel gauge doesn't work. It just blinks and reads empty. I read on here somewhere that folks have had success wiring a carb float to the existing float. I plan to try this but I want to know if I have to worry about anything when I remove the fuel...

I am sure many of you have seen this post before. Sorry if it is getting redundant... There should be a delineation between Carburated and EFI applications as they are significantly different. It can be confusing for users that are less mechanically inclined. I have read folks replies that...

I have a dead fuel pump wiring harness, Pump works (jumper wire to test). It is a 2002 500 Ranger So I went to the local Polaris shop and asked questions, such as could I by pass and just wire fuel pump in to the ignition switch? Yes was the answer and on the back of the ignition switch is a...

This is my first question since joining but i've done some reserach as a guest. Have run into a problem i've not seen addressed. I was haveing what seems to be a common problem with the fuel pump getting hot on my 2005 Polaris Ranger and it stops pumping resulting in stranding me in the woods...