Search Results for ‘wiring’

Hello, I recently picked up a 2014 ranger 800 midsize. It has a Polaris winch, aftermarket cab heater and light bar. The accessories all use relays and the switches use the positive power keyed post on the bus bar under the hood. The issue I’m seeing is after I turn the key off the light on the...

I have a 2017 ranger 1000xp Fuel pump not coming on during start. Jumped pump with 12v and runs fine. Replaced relay, ignition switch, fuses, tmap sensor, and ecu. Still no joy. Can’t see any chewed wires. Any ideas? Looking for wiring diagram to see if ecu is sending signal to relay to engage?

I installed a 50" Rough Country LED lightbar on my 2021 Ranger 1000XP. I used the the wiring harness provided with the lightbar, which included a relay and a 30 AMP fuse. I bought the pigtail for the pulsebar and wired the middle(key on power wire) to the lightbar power line. I taped off the red...

I recently purchased an ecoxgear audio speaker to mount and hook up on my ranger 570 midsize. It comes with wiring that goes to batter directly to the speaker but I want to install a toggle switch in the dash to use as well. How do I connect the toggle switch into the speaker wiring and not just...

Hi all! I recently purchased a 2011 Polaris Ranger EV from an individual. When attempting to charge it, I nothing happened and the lights - or lack thereof- indicated that it wasn’t getting any AC. After opening the charger up, I found the AC fuse blown, although there were no signs of any...

I want to add 12V power supply wiring for an a new accessory on my new Polaris EV. I think it needs to be wired in at the Auxiliary 12V Terminal Board, so would like any info such as how to access the terminal board wiring, wiring diagram or any helpful pictures, etc on how to do this.

Hi guys, Recently installed the windshield kit and right now the windshield turns on even when the key is not in the ignition, I was wondering if there is a way to wire it so that it only works when the key is turned on. For example the headlights are switched on all the time but only light...

I am installing a 30" light bar on my 2014 ranger 900xp and was wondering where a good place to make a tap off of the lighting circuit would be? I want to tap off of the existing circuit so the lights cant be turned on without the ignition on. I am going to wire through a separate switch and...

Hi, Anyone install a rear bumper (standard bumper) on a 2013/2014 570? The direction call for redirecting the tail light wiring through the holes of the bumper mounting bracket. Easy enough, until they tell you to unclip the main connector and work it through the holes, however, the left and...

I have a cab light hooked up to the bottom post of the power bar by the fuse box under the hood. If i remember correctly that post had power all the time. The light quit working so i checked all the fuses in fuse box and didnt find any of them blown. Are there other fuses or fuse box somewhere...

I have a 2011 Ranger Crew 500 efi and was installing a winch. While doing so I accidentally arced the bottom two screws of the row of three screws on the drivers side under the hood on the frame. What are those and is there anything I should be worried about? I checked all the fuses and they...