Polaris Ranger Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hey guys I've done a lot of reading gov er the net but cant seem to find my answer. I have a 19' Ranger XP 1000EPS and noticed a crack in the lower A Arm weld, I'm looking to upgrade these little factory arms. Does any one have experience with a good aftermarket company for this upgrade?

Any help would be greatly appreciated..

Thank you
 

·
Vendor
Joined
·
254 Posts
Hey man! Got you covered. We have two different options.
Hit me up if you're interested and I'll get you a little discount.
 

·
Registered
Joined
·
170 Posts
I upgraded to the Super ATV forward A arms. The only issue was the grease zerks. The threads in the A arms or the zerk threads weren't the best and a couple would pull out when you'd try to pull or pop the grease gun hose off. I did call customer service and the girl sent me out a new pack of zerks no charge.
And the other issue I had was alignment of the front end after install. I spent five or six hours over a week or two trying to get the castor camber right. I got it very close and finally took it to the dealer and let him finish it off.
Be sure to install the steering stop clips or you'll rip the U joint rubber boots like I did.
 
1 - 3 of 3 Posts
Top