Polaris Ranger Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I used my ranger yesterday. Today i go out and nothing. I replaced the ignition switch a couple of weeks ago. Today I have tested the switch and have continuity where I should. Have power to switch. Have fully charged battery and installed new starter relay. I am lost. Any ideas or suggestions?
 

·
Registered
Joined
·
11 Posts
In the same boat ... will look around on here and see if I can find all the ohm readings for coil, spark plug cap and stator. I have had Polaris dealer replace stator twice and finally did it myself with a rebuild from Canada worked great, think the P-house did not have the gap set right or something. Hope not the stator again.
 
1 - 2 of 2 Posts
Top