I used my ranger yesterday. Today i go out and nothing. I replaced the ignition switch a couple of weeks ago. Today I have tested the switch and have continuity where I should. Have power to switch. Have fully charged battery and installed new starter relay. I am lost. Any ideas or suggestions?
In the same boat ... will look around on here and see if I can find all the ohm readings for coil, spark plug cap and stator. I have had Polaris dealer replace stator twice and finally did it myself with a rebuild from Canada worked great, think the P-house did not have the gap set right or something. Hope not the stator again.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Polaris Ranger Forum
129.2K posts
39.6K members
Since 2007
A forum community dedicated to Polaris Ranger owners and enthusiasts. Come join the discussion about performance, modifications, winches, tires, troubleshooting, maintenance, reviews and more!