Polaris Ranger Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Sure, our Ranger goes over mountains, through mud and snow, down dried stream beds and old skid trails, hunts, fishes and does yard chores, but sometimes it’s just me and the misses going down river a few miles to an neighbor’s for dinner or a pot luck. The bed is obviously molded to allow for dividers to keep smaller loads from tumbling around, but I don’t see any for sale. The slots are wide and look like they’d take a 2x10, but before I buy and cut one I thought I’d ask if anyone has a better solution they are using.

Thanks in advance!

[email protected]
 

·
Super Moderator
Joined
·
2,273 Posts
You are correct. That is what they are designed for. Common readily available lumber for dividers.
Someone might make something specifically for that but I have never seen it either.
 

·
Registered
Joined
·
6 Posts
Discussion Starter #3
The molded slots are rather wide, that’s why I said 2x10 or maybe even 2x12. It will be pretty heavy for my wife, so I was hoping there was a molded product available. Thanks for your input!
 
1 - 4 of 4 Posts
Top