Polaris Ranger Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
I have a 2017 polaris 1000 xp high lifter, that died in deep water and sucked water up tail pipe. It cranked long enough to winch out of water and the died. It hasn't cranked since. Its giving me miss fire codes on cluster. Could someone steer me in the right direction ?
 

·
Registered
Joined
·
6 Posts
Hopefully you pulled your spark plugs before attempting to start, than you have to open up your air box and than try starting.i highly recommend checking, and changing your oil and transmission fluid
 

·
Registered
Joined
·
6 Posts
Also the stock snorkel system runs up front of the machine runs under floor boards than comes back uphill to the engine so there for you should check in there also to make sure there's no water in the system or it will not fire,and if there is water in there you will be shooting it back in to the engine! I've been there done that,but I caught it ahead of time
 

·
Registered
Joined
·
6 Posts
Discussion Starter #4
I did drain all fluids and water . I came up exhaust, not the snorkels. Its will fire and idle for a few seconds like something is still wet. I have checked everything.
 
1 - 7 of 7 Posts
Top