Polaris Ranger Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Does anyone know what light is available for the two openings on the front below the headlights? There is three mounting tabs behind it so I'm sure something was designed for it. Also, anyone have a blank for it, either plans or 3D printing?

23582
 

·
Registered
Joined
·
40 Posts
I’m not certain, but I know that rangers that went over seas had factory turn signals. Those front holes might be where they mounted the signal lights.


Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
20 Posts
I 3D printed housings for my 570 FS. Not sure if the XP900 is the same.
PM me and I can send either stl files or Fusion 360 files.

Sent from my SM-G975U using Tapatalk
 

·
Registered
Joined
·
2 Posts
Discussion Starter #5
I 3D printed housings for my 570 FS. Not sure if the XP900 is the same.
PM me and I can send either stl files or Fusion 360 files.

Sent from my SM-G975U using Tapatalk
I started a "conversation" with you so don't know if you rec'd it or if I did something wrong. I couldn't find the PM link so that's what I did.
 

·
Registered
Joined
·
20 Posts
I started a "conversation" with you so don't know if you rec'd it or if I did something wrong. I couldn't find the PM link so that's what I did.
No, it's me! I got your pm but haven't had a chance to send it yet. Been having software issues with my cnc mill that's been absorbing my free time.
I'll be sure to send it this afternoon.
Sorry for the delay.

Sent from my SM-G975U using Tapatalk
 
1 - 8 of 8 Posts
Top