Polaris Ranger Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a 2011 Ranger Crew 500 efi and was installing a winch. While doing so I accidentally arced the bottom two screws of the row of three screws on the drivers side under the hood on the frame. What are those and is there anything I should be worried about? I checked all the fuses and they are good. The units starts and drives well, without any engine warning light or other problems except there is a clicking sound around the engine for a few seconds after I turn it off, which may be new, or may not as I don't remember it happening before. Anyone's help will be greatly appreciated.
 

·
Registered
Joined
·
19 Posts
I'm not positive but on mine those 3 screws are a ground a positive 12v and a 12v with the key on. I don't know if they are fused. But if you still have power on them then they are fine. On mine the book says it's for hooking up the factory winch. Hope this helps
 
1 - 3 of 3 Posts
Top